How to make a pvc fork seal driver

Download Driver Here --> https://tinyurl.com/2amtde2e (Copy and Paste Link)

 · Thanks to Moonfleet  · 1,) Cut a 4 inch length of inch diameter PVC. 2.) Cut that piece lengthwise into 4 separate pieces. 3.) File a bevel (about 30 degrees) on the side of the bottom (the end that will contact the seal) of each piece - this allows the PVC to fit into the gap between the inner and outer tubes of the fork.  · Yup. Just a roll of electrical tape and mallet.

1,) Cut a 4 inch length of inch diameter PVC. 2.) Cut that piece lengthwise into 4 separate pieces. 3.) File a bevel (about 30 degrees) on the side of the bottom (the end that will contact the seal) of each piece - this allows the PVC to fit into the gap between the inner and outer tubes of the fork. I use a length of 2" pvc, then split it with a saw for about 8 inches up. Several splits remove enough material and make it flexible enough. that it will then fit most fork seals. But, after using it for several years, and for many bikes, I finally. bought a $35 adjustable seal driver that fits mm forks. Short video I made describing a cheap 49mm fork seal driver for and later dyna model Harley-Davidsons using 2" x 24"long pvc.

I know there are ways to install them without a fork seal driver. I have seen a few vids where they made them from pvc pipe and a couple clamps. Feb Okay, I'm gonna post this the ST and the suspension forums Anybody who has made/used a PVC pipe for a fork tube seal installer. How To. Motorcycle Fork Seal Driver Tool Out Of PVC Tubing. Diy. 24, views24K views. . Dislike. Share. Save.